CPI GP8, Operating Instructions Manual

Page - 9 

SALES +  SERVICE

CPIGP8AOPINST 

   (866) 912-3469 

                WWW.CPISHINE.COM 

To verify correct placement of the brushes, try to rotate them clockwise and then pull lightly 

upwards: if the brush does not come off the support, placement is correct. 

ELECTRICAL CONNECTION 

First, verify that the power supplied corresponds to the machine's requirement by checking the 

data on the label attached on the right hand side. Check that the electric plant and the socket 

are suitable to supply a domestic appliance with a power of 1.8 Kw. If the socket does not 

correspond to the plug, ask an electrician to change it. Do not employ an 

adaptor as this may cause overheating and burning.   

Never use an extension cord to reach the electric cable to the outlet.  If the cable is not long 

enough, reposition the glass polisher nearer to the outlet or have an electrician change out the 

cable for a longer cable. 

Ensure the cable does not rest on sharp edges and is not compressed or bent by other 

objects. 

STARTING THE MACHINE FOR THE FIRST TIME 

This is the same procedure that you would engage for all subsequent start ups of the machine. 



  Ensure the glass drier is placed in a location where the operator will find it comfortable 

to operate. 



  Ensure nothing is placed under the glass polisher that could obstruct air flow – i.e.  

cloths  



  Insert the plug into the nearest socket. 



  Press the “Power” button located on t he front of the dryer to start up 

the machine.   

a.  The button will illuminate indicating there is power to the unit. 

b.  The brushes will begin to rotate 

c.  The calrod element heats up 

d.  The fan will begin to circulate increasingly warm air around 

the brushes. 

WARNING:  Ensure that no objects get caught in the rotation of the brushes. 

 
Allow the brushes to heat up for approximately 10 – 15 minutes before 
using the GP8 to dry glasses.