The Talos bill validator will not need to be cleaned as often as magnetic
sensing bill acceptors. If cleaning is required, use a soft cloth moistened
with a mild, non-abrasive detergent.
Compliance
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (a)
This device may not cause harmful interference, and (b) this device must accept any interference received,
including interference that may cause undesired operation.
Except as permitted under the relevant local legislation, no part of this publication may be copied, trans-
mitted, transcribed, or distributed in any form or by any means, or stored in a database or retrieval system,
or translated in any language (natural or computer), without the prior written permission of CPI. MEI UK
International, MEI Cashflow® and the MEI device are registered trademarks.
CPI reserves the right to change the product or the product specifications at any time. While every effort
has been made to ensure that the information in this publication is accurate, CPI disclaims any liability for
any direct or indirect losses (howsoever caused) arising out of use or reliance on this information. This
document does not necessarily imply product availability. Note: Your product may differ slightly from some
of the illustrations in this document.
CPI Corporate Headquarters
3222 Phoenixville Pike
Suite 200
Malvern, PA 19355
CranePI.com
Troubleshooting
bezel led error flash codes
talos t700 install guide
When the unit is ready and enabled, the bezel LEDs will flash continu
-
ously. If the bezel LEDs are off, the unit has an error. To determine the
error, partially insert and hold a bill in the bill path until the bezel lights
flash. Count the flashes and refer to the chart below.
These are some common, easy-to-solve issues that may pop up during
installation:
The Talos bill validator is designed to fit into the standard bill acceptor
opening in most vending machines and can be mounted on existing
studs or a mounting bracket.
Features
–
Four way bill acceptance
–
Coupon and bill configuration
–
Supports High Visibility and Credit Card Reader Bezels
Interface
The Talos bill validator operates via MDB interface. The 24VDC MDB
harness is included.
Operating Voltage
See the label on the side of the device.
Flashes
Problem
Solution
None
No power
Restore power to validator or machine
1 or 4
Bill path
blocked
Check for jams. Remove bill
magazine and lower housing
assembly and inspect
2
Another
vending
component
Ensure the unit has been enabled,
then check:
• Vending Machine Controller
• Coin manager and coin levels
• Inventory levels
• The door is locked properly
3
Lower
housing
assembly
Check that the lower housing
assembly is seated. Ensure bill path
is clean; see Cleaning section
5
Bill magazine
removed
Reattach bill magazine
Continuous
fast
Stacker full
Empty the bill magazine
Continuous
slow
Unit is
defective
Replace the unit
If this happens
Try
The unit will not power
up
Check Harnesses: Cables may be
loose, not properly connected or pins
may be bent
Check Source Voltage: Ensure that
power is being supplied to the bill
validator.
The unit has power, but
will not accept a bill
Ensure the unit has been enabled, then
check:
• Vending Machine Controller
• Coin manager and coin levels
• Inventory levels
• The door is locked properly
cleaning
Talos_Install_Guide_5.24.19.indd 1
5/24/2019 9:54:44 AM
