MAINTENANCE
1) The collection cup should be emptied regularly. Every time you empty the cup, clean the base of the funnel
and the inside of the throat for better collection.
2) The
AeroForce 2
TM
should be cleaned every three months, or as needed.
3) Clean the powerheads at least once a month. Replace each powerhead every twelve to eighteen months to
ensure optimal performance.
To clean the powerheads, follow the “Removal and Cleaning of your Powerhead”
instructions below.
REMOVAL AND CLEANING OF YOUR POWERHEAD
1) Remove the inner body from the outer body then remove the pump and base plate from the inner body
2) Remove the Pico 400 pump by pulling straight down on the pump from the inlet part 2.
3) See the next page for pump disassembly images to assist in taking them apart. Remove the airline by
pulling away from the powerhead. During disassembly, ensure that no pieces are misplaced. The Pico 400
pump includes a small clear translucent bushing that the impeller rod fits into (inside red cap) and is
required for quiet operation. It can pop out, so please be careful during disassembly.
4) Wash all parts under warm tap water. Do not use any detergents. Make sure that the air line is clear of
any foreign matter, calcium buildup or salt creep before reassembling.
5) Place the powerheads back in place on your
AeroForce 2
TM
8) Plug in the feed pump (9) first. Once the skimmer pump becomes submerged, plug in the skimmer pump (8).
Your AeroForce 2
TM
is now operational.
9) Place the collection cup (1) in the skimmer column of the unit.
The base of the collection funnel should be 1/8”
below the water surface for optimal performance. Slide the O-ring (2) up or down until the desired skimmate wet-
ness is achieved.
It is common that some of the micro-bubbles escape to the tank during the initial set up. The surface tension may rise
due to the oils on the acrylic, additives and/or water conditioners being introduced to the water. The skimmer may pro-
duce excess bubbles until it is able to break down whatever is raising the surface tension of the water. This process can
take from a few days to a number of weeks to clear completely
