Understanding Your Controls
The control box is mounted to the cross bar of the G-250XTP.
The throttle control is located on the left side upright of the frame.
The following controls are used to operate the machine on the
job site:
1. START- Depress this button to start the machine’s engine. While
starting the engine, it is IMPORTANT that the throttle is adjusted to
the lowest RPM and then increase RPM once engine is running.
2. E-STOP– Utlize this button to turn the machine off. *IT IS
RECOMMENED TO REDUCE THE MACHINE’S RPMs PRIOR TO
DEPRESSING THE E-STOP BUTTON.
3. USB PORT- For your convience, there is a USB Port located on the
bottom of the control box.
IMPORTANT! Do not leave the G-250XTP standing in one place
during the shut down phase. Always keep the machine in motion
until the head has come to a full and complete stop to avoid creating
a ‘doughnut’ or ‘swirling’ design on the floor.
CONTROLS
24/7 Technical Support- Toll Free 1-877-472-8200
12
Concrete Polishing Solutions- G-250XTP Operator’s Manual
