ASSEMBLY INSTRUCTIONS
Set Drill Press Table approximately 6
inches from the Drill Press chuck.
Align Drill Press Table with Drill Press
chuck. Once aligned, lock table with
table lock.
Attach Table Mount to Drill Press
table using 1/4 inch connector
bolts/washer/nuts thru mounting
slots. Hand tighten at this point.
Attach both Alignment Plates to Table
Mount by inserting the 1/4 inch
connector bolts/washers/nuts into
the designated holes of Table Mount.
Hand tighten at this point.
Step 1 - Aligning Drill Press Chuck and Drill Press table
Step 2 - Attaching Table Mount
Step 3 - Attaching Alignment Plates
Summary of Contents for CPDP-104
Page 10: ......
