Act1 Electrofusion Welder
06/06/2011
www.ProcessPipes.co.uk
Pg 6
Intended Use
This equipment is intended to weld constant voltage electrofusion fittings suitable for low,
medium and high pressure pipe work systems.
This welding unit has been approved in the UK by Transco to the standard T/SP/ECE/1 2005
‘Specification for Electrofusion Control Boxes’, and is approved for use on all UK gas distribution
networks.
This welding unit complies with the UK Water Industry Specification WIS 04-32-08 ‘Specifications
for the fusion jointing of polyethylene pressure pipeline systems using PE80 and PE100 materials’,
and is suitable for use on all UK water distribution networks.
This welding unit has been designed to comply with the International Organization for
Standardization standard ISO12176-2:2000 "Plastic pipes and fittings, equipment for fusion
jointing polyethylene systems , part 2, electrofusion".
Introduction
This manual gives instructions on the correct assembly and safe use of your welding unit. It is
important that you read these instructions carefully, and keep these instructions for the life of the
unit.
This manual does not detail the specific welding procedure for the fittings: scraping, clamping and
assembly of joints. For this information you must contact the manufacturer of the fittings.
Delivered Items
Carefully remove the welding unit from its packaging and check that you have the following items:
•
Welding unit.
•
Welding cable.
When parts are missing or damaged, please contact your dealer.
Summary of Contents for Act1
Page 1: ...Act1 Electrofusion Welder ...
Page 27: ......
