35
*3-Function Remotes (315 MHz)
If provided with your garage door opener, the large button is
factory programmed to operate
it. Additional buttons on any
Security
✚
®
3-Function remote
or compact remote can be
programmed to operate other
Security
✚
®
garage door
openers.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the “learn” button on motor unit
until the learn indicator light goes out
(approximately 6 seconds). All previous codes
are now erased. Reprogram each remote or
keyless entry you wish to use.
Press and release the “learn” button on
1.
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
Within 30 seconds, press and hold the
2.
button on the hand-held remote
*
that you
wish to operate your garage door.
Release the button when the motor unit
3.
lights blink. It has learned the code. If light
bulbs are not installed, two clicks will be
heard.
PROGRAMMING
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will
open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security
✚
®
315 MHz remote controls.
NOTICE:
If this
Security
✚
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver of
the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the copyright in the
garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical
measure.
LOCK
LIGHT
Press and hold the button on the hand-held
1.
remote
*
that you wish to operate your
garage door.
While holding the remote button, press
2.
and hold the LIGHT button on the door
control.
Continue holding both buttons while you
3.
press the push bar on the door control
(all three buttons are held).
Release buttons when the motor unit
4.
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
LOCK
LIGHT
LOCK
LIGHT
LOCK
LIGHT
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON
USING THE DOOR CONTROL
