8
Front Rail
(TO DOOR)
Window
Cut-Out
Screwdriver
Idler
Pulley
Hole
Tabs
Back Rails
(TO MOTOR UNIT)
Trolley
Tapered
End
Tapered
End
Inner Trolley
Wear Pads
Outer Trolley
Tapered
End
Tapered
End
FRONT RAIL
(TOP)
KEEP LARGER
HOLE ON TOP
ASSEMBLY STEP 1
Assemble the Rail & Install the Trolley
To avoid installation difficulties, do not run the garage door
opener until instructed to do so.
To prevent INJURY from pinching, keep hands and fingers
away from the joints while assembling the rail.
The front rail has a cut out “window” at the door end (see
illustration).
The hole above this window is larger on the top of
the rail
than on the bottom. A smaller hole 3-1/2" (8.9 cm) away
is close to the rail edge. Rotate the back rail so it has a similar
hole close to the
opposite
edge, about 4-3/4" (12 cm) from the far
end.
Remove the straight door arm and hanging bracket packaged
1.
inside the front rail and set aside for Installation Step 5 and 12.
NOTE:
To prevent INJURY while unpacking the rail carefully
remove the straight door arm stored within the rail section.
Align the rail sections on a flat surface as shown and slide the
2.
tapered ends into the larger ones. Tabs along the side will lock
into place.
Place the motor unit on packing material to protect the cover,
3.
and rest the back end of the rail on top. For convenience, put a
support under the front end of the rail.
As a temporary trolley stop, insert a screwdriver into the hole
4.
10" (25 cm) away from the front of the rail, as shown.
Check to be sure there are 4 plastic wear pads inside the inner
5.
trolley. If they became loose during shipping, check all packing
material. Snap them back into position as shown.
Slide the trolley assembly along the rail from the back end to
6.
the screwdriver.
