8
UNPACKING
The machine is properly packaged and
shipped completely in a carton for safe
transportation. When unpacking, carefully
inspect the carton and ensure that nothing
has been damaged during transit. Open it
and check that the machine and the parts
are in good condition.
CONTENTS QTY
A.
Collector Body & Motor Assembly ...... 1
B.
Motor Bracket ..................................... 1
C.
Wall Mounting Bracket ....................... 1
D.
Dust Collection Bag............................ 1
E.
Bag Clamp ......................................... 1
F.
Foam Strip.......................................... 1
G.
Wrench............................................... 1
H.
Hardware Bag .................................... 1
While doing inventory, if you can not find
any part, check if the part has already been
installed on the machine. Some parts come
pre-assembled for shipping purposes.
ASSEMBLY
To assemble your CX416 Wall Mount Dust
Collector, follow the instructions given
below.
Align the holes on the motor bracket with
the holes on the motor base and attach the
motor bracket to the motor base using four
bolts provided as shown in figure-1.
Figure-1 Attaching motor bracket to the
motor base
Take the wall mounting bracket and use it
as a template on the wall. Mark the
mounting the holes with a pen and make
sure the mounting bracket is 44” (minimum)
from the floor and 6” (minimum) away from
the wall so that the motor have enough air
cooling space.
Figure-2 Installing the wall mounting
bracket
If you are installing the wall mounting
bracket on a concrete or masonry wall, use
lag screws with lag shield or anchor studs.
