12
Figure-11 Squaring table to the belt
Figure-12 Squaring table to the disc
SANDING BELT
REPLACEMENT
To replace the sanding belt:
Make sure the switch is in the OFF position
and the cord is disconnected from the
power source.
Remove the upper guard and the side
cover by removing the lock knob and
loosening the two screws securing the
upper guard and the side cover. See figure-
13.
Figure-13 Removing the side cover
The middle roller features spring at the
back and can be pushed towards the table.
To remove the belt, hold the adjusting shaft
guard and apply moderate pressure just to
loosen the belt tension and push it towards
the table. See figure-14.
Figure-14 Replacing the belt
Summary of Contents for CT170
Page 1: ...CT170 1 x30 BELT 5 DISC SANDER User Manual ...
Page 6: ...6 CT170 1 x30 BELT 5 DISC SANDER PHYSICAL FEATURES ...
Page 14: ...14 ...
Page 15: ...15 ...
