9
GRINDING SURFACE
The grinding surface of the wheel should be
parallel with the universal support.
Make sure the switch is in the OFF position
and the cord is disconnected from the
power source.
Lower the universal support 1/8” above the
grinding wheel and check if the grinding
surface of the wheel is parallel to the
universal support by rotating the wheel
slowly with your hands.
Figure-4 Checking the grinder wheel
surface parallelism with universal support
TEST RUN
Once you have assembled and inspected
the machine it is then time to do a test run
and see if the machine powers up and runs
properly.
All the tools and objects used for
assembling the machine should be
removed and cleared away during test run.
Connect the machine to the correct power
source and start the machine. During the
test run if there is any unusual noise or
vibration, disconnect the machine from the
power source immediately. Check all the
parts you have assembled, once again and
try to find out the problem.
During the test run make sure the start/stop
button and all the safety features on the
grinder are working properly.
WARNING!
Do not make any adjustments while the
machine is running. Turn the machine
OFF and un-plug from the power source
before making any adjustments. Failure
to do so may cause serious personal
injury.
Summary of Contents for CT191
Page 1: ...CT191 10 WET BENCH GRINDER USER MANUAL Version 1 0 ...
Page 14: ...14 ...
Page 15: ...15 ...
Page 16: ...16 ...