15
Remove the blade guard and use a screw
driver to loosen the screws located on each
of the two guide bearings as shown in
figure-21.
Figure-21 Set Screws
Adjust the bearings so that the space
between the bearing and the blade should
be 0.02” which is thickness of a sheet of
paper. See figure-22
Figure-22 Distance between the guide
bearings and the blade
Now, retighten the set screws to lock the
guide bearings in place.
Loosen the lock levers shown in figure-23
and move the bearing shafts in or out so
that the guide bearings are 1/32” behind the
blade teeth and the thrust bearing, 1/64”.
Once the bearings are at the correct
position behind the blade, tighten the lock
lever to lock the bearings in place. See
figure-23.
Figure-23 Distance of the bearings behind
the blade
Adjust the lower bearings in the same
manner.
Table Stop Adjustment
CX101 features a table stop which allows
the table to easily come to a 90° if the table
is tilted.
To adjust the table stop so that the table
sits at 90°, you should first make sure the
switch is in “OFF” position and the power
cord is unplugged. Loosen the two lock
knobs under the table and loosen the hex
nut which locks the table stop bolt.
Now, place a square on the table as shown
in figure-24 and adjust the table stop so that
the table is at a 90° with the blade.
