4
CX104
is designed for cutting wood
only.
ALWAYS
INSPECT
the blade for any
cracked or missing teeth before
operating the band saw.
ALWAYS
ENSURE
that the blade
tension is properly set for the type and
width of blade installed.
NEVER
place your fingers or hands in
the line of cut. If you slip, your hands or
fingers may come into contact with the
blade. Always use a push stick when
ripping narrow pieces.
DO NOT
back the work-piece away from
the blade while cutting. Always turn off
the machine if you are backing out a cut.
ALL GAURDS
must be in place while
operating the band saw to ensure
safety.
ALWAYS
FEED
the stock smoothly. Do
not force or twist the work-piece while
cutting.
ALWAYS
ENSURE
that the band saw
blade guard is no more than 1/2” above
the stock.
MAKE SURE
before making any
adjustments, the switch is in the “OFF”
position and the cord is un-plugged from
the power source.
NEVER LEAVE
the band saw
unattended while it is running.
DO NOT
attempt to remove jammed
pieces unless the band saw has come
to a complete stop and the power switch
has been turned to the
OFF
position.
NEVER
TURN ON
the band saw if the
blade is in contact with your stock.
ALWAYS
ENSURE
that the guide
blocks are properly set to prevent blade
wander.
ALWAYS MAKE CERTAIN
that the
bearings are properly adjusted to guide
the blade.
MAINTAIN AND SERVICE
your band
saw regularly as instructed in the user
manual.
MAKE SURE
you have read and
understood all the safety instructions in
the manual and you are familiar with
your band saw, before operating the
CX104. If you fail to do so, serious injury
could occur.
CX104 14” WOOD BAND SAW
SPECIFIC SAFETY INSTRUCTIONS
WARNING
The safety instructions given above can not be complete because the environment in
every shop is different. Always consider safety first as it applies to your individual
working conditions.
