Craftex CX112, User Manual

- 8 - 

Fig. 4 

Item Attached 

Parts Q’TY

1 

Stop Rod Assembly (E)

Fig.4 

1set

2 

Instrution 

Manual                           1

6. Description and Characteristics 

1.  This 

CX112

 portable band saw is made as 

light as

23 kg

by weight 

allowing easy

transport to any worksites. 

2.  Th

e

 machine frame is cast 

aluminum.

The base 

is 

formed by the steel so 

that body construction becomes stronger 

and smoother. 

3.  During operation, the noise level of th

e

machine is about 60 db, which is much less 

than any of the other band saws, and of 

course, it 

features

 a comfortable 

working environment. 

4.  This machine 

features easy

 blade 

tension

adjustment

.

Hold

 the handle to 

give a little turn for the tension increasing, 

or decreasing as you wish

 while

changing

blade or 

when the 

machine in 

operation.

It a

lso 

has 

compression 

spring attached

which is 

for reducing vibration 

produced when

cutting 

defective work piece

.

It permits the blade to be used much longer. 

5.  The drive of this machine is through gear 

transmission that gives steadier, stronger, 

and smoother cuts superior to any of pulley 

drive band saws, and make less trouble 

after service. Note: If anything unusual 

happens on your gear transmission system, 

do not try to fix or restore it personally. 

Send it back to your dealer for check-up or 

repair. Failure to comply can result in 

machine damage. 

6.  The machine combines miter, and 

horizontal cutting and is designed for full 

efficiency and operator

's

 convenience in 

each position. 

WARNING

SHUT OFF THE POWER SOURCE ALL THE 

TIME, BEFORE THIS MACHINE IS IN 

MAINTENANCE, OPERATION, ADJUSTMENT, 

OR REPAIRMENT. 

WARNING

Disconnect machine from the power source! 

No matter when, where, or how. Pay extra 

attention to the saw during it in transportation, 

operation, maintenance, or adjustment. 

Failure to comply may cause serious injury!

7. Operating 

Information before Operation 

Be sure the blade isn’t in contact with the work 

when the motor is started. 
Run the motor allow the saw to come to full 

speed. Begin the cut by letting the head down 

slowly onto the work. 
DO NOT DROP. Use the handle of trigger switch 

operating by hand. 
Press green button down (Fig. 5) to turn on the 

power and press and hold the trigger switch 

(Fig.6) for manual cutting. 
Finish cutting or stop the cutting by press

ing

down the red button or release the trigger 

switch. 

Fig. 5 

Fig. 6 

Trigger switch

E 

ON/OFF switch