10
Figure-6 Attaching the table tilt bracket
Once the table is in the correct position,
tighten the table lock knobs under the table
and the tilt lock knob.
Install the table insert at the center of the
table and the table pin into the table slot as
shown in figure-7.
Figure-7 Installing table insert and table pin
Take the fence rail and attach it to the table
using cap screws provided. See figure-8.
Figure-8 Fence rail installed
Now take the fence and pull its handle up
(in the unlocked position). Place the fence
on the fence rail and slide it towards the
blade.
Figure-9 Installing the fence
Attach the miter gauge holder and the fence
holder to the back of the saw using screws
and washers provided see figure-10.
Figure-10 Miter gauge holder and fence
holder installed
