11
TEST RUN
Once you have assembled your dust
collector, it is then time for a test run to
make sure that the machine works properly
and is ready to use.
Remove all the tools used for assembling
the machine components. Walk around the
machine, ensure all nuts, bolts, and screws
are tightened and the machine is properly
assembled. Connect the cord to the power
source and turn the machine ON.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, turn OFF the
power switch immediately and disconnect
the cord from the power source. Investigate
if you can find out the problem with your
machine.
OPERATION
Operating the CX404 dust collector is very
simple and straightforward.
Make sure the dust collector is properly
assembled and worked during the test run.
Move the CX404 close to the machine and
use a proper sized hose connecting the
hose with its one end to the machine and
the other end to the dust collector.
Make sure the connections are secured
using hose clamps and connect the ducting
ground and the dust collector is ready for
operation.
FORMULAS
Velocity (FPM)
= Volume (CFM) / Cross
Sectional Area (ft.
2)
Volume (CFM)
= Velocity (FPM) x Cross
Sectional Area (ft.
2)
Cross Sectional Area (ft.
2
)
= Volume
(CFM) / Velocity (FPM)
Circle Area
= 3.142 x Radius
2
Diameter
= 2 x Radius
WARNING
Do not make any adjustments while the
machine is running. Turn off the
machine and un-plug from the power
source before making any adjustments.
WARNING
Before starting the machine, make sure
that you have read and understood the
user manual and you are familiar with the
safety features of the machine. Failure to
do so may cause serious personal injury.
WARNING
Do not use the CX404 for any other
operation other than collecting sawdust.
Failure to do so could result in
malfunction of the machine and may
void the warranty.
