16
Figure-15 Automatic feed lever
CHANGING GEARS
The gears on CX704 can be changed for a
variety of different feed rates.
Figure-16 Gears and adjuster
TO CHANGE THE GEARS:
Make sure the cord is disconnected from
the power source.
Remove the gear cover to access the
gears. Loosen the adjusted to disengage
the gears from each other.
Remove the gears and install the new
gears according to the chart. See figure-17
& 18.
Reinstall the adjuster and close the close
the cover.
Figure-17 Threads per inch chart
Figure-18 Metric thread chart
WARNING!
DO NOT change the direction of rotation
of leadscrew while the lathe is running.
Failure to do so could result damage to
the lathe.
Summary of Contents for CX704
Page 1: ...CX704 7 x 12 MINI METAL LATHE User Manual ...
Page 21: ...21 WIRING DIAGRAM FOR CX704 ...
Page 22: ...22 ...