9. Blade Assembly.
Remove 1 screw from fitter plate (on the
underside of the motor housing) and loosen
the other 2 screws.
Connect
WHITE
wire from light kit fitter to
WHITE
wire from motor housing. Connect
BLACK
wire from the light kit fitter to
BLACK
(or
BLUE
) wire from the motor housing. Be
sure that the molex connections snap
together securely.
Align slotted holes in light kit fitter with
loosened screws on fitter plate; twist light kit
fitter to lock. Re-install screw that was
previously removed and then securely tighten
all 3 screws.
Install 3 candelabra base 40 watt max. bulbs
(included).
Important
: When replacing bulbs, please allow
bulbs and glass shade to cool down before
touching.
Align hole in glass shade with threaded rod on
light kit fitter and push up gently until
threaded rod comes through hole. Align hole
in center of finial plate with threaded rod and
push up. Secure glass shade with finial.
Do NOT
overtighten finial as glass may crack or break.
Time Saver:
Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in a hardware pack. Slide blade into slot on side
of motor housing (
please note side of blade
indicating
THIS SIDE UP
), then align holes in
blade with holes on blade plate located
inside
motor housing. Insert 3 blade attachment
screws (along with washers) from
underside
of
motor housing. Tighten screws securely with a
Phillips screwdriver. Repeat for remaining blades.
Note
: Tighten blade arm screws twice a year.
motor housing
blade
page 7
10. Light Kit Assembly.
molex connections
fitter plate
bulb
light kit fitter
glass shade
finial
motor housing
finial plate
blade plate
threaded
rod
blade attachment
screws and washers
