10
Step 10
For added security, attach safety cable from fan unit to "J" hook (S10) in
outlet box. Secure by looping zip tie (S11) through safety cable and "J"
hook. Tighten zip tie securely. Lift fan onto the mounting bracket (#1).
Turn housing until hanging ball seats itself into ball socket (listen for
click).
NOTE
: Parts furnished will allow
you to install your fan at up to a
35º angle. Angles greater than 35º
will require a 45º angle adapter
(see dealer).
NOTE
: J Hook
installation is a Canadian
requirement only.
Outlet Box (A)
Support Beam
Ceiling
Green Ground Wire
“J” Hook (S10)
OUTLET BOX
“J” Hook (S10)
Safety Cable
Zip Tie (S11)
Mounting Bracket
WARNING:
To reduce the risk of fire, electric shock or personal injury, mount
so outlet box marked "acceptable for fan support" and use mounting screws
provided with the outlet box. Most outlet boxes commonly used for the support
of lighting fixtures are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
Step 11
1. Connect fan wires to ceiling wires: white fan wire to white outlet wire,
black to black and green to green. Wire connectors (S6) are provided for
your convenience. If an additional blue wire is present then also connect
the blue wire to the black wire. (Optional light kit may be wired to
individual wall switches, if desired.)
2. After connections
are made, turn
splices upward
and push carefully
into outlet box.
Separate blue and
black wires on one
side of the box, and
white and green wires
on the other side.
There are 4 colored
wires coming from the
top of the motor
(including ground wire).
11
White (Neutral)
Ground
White
Black
Wire
Connectors
(S6)
Ground
(Green)
Blue
Black (Power)
Outlet Box
Ground
(Green)
Mounting
Bracket
Wire Connnections
Outlet Box
Fan wires
Black
Black
(Hot wire for fan)
Green
Green
(Ground wire)
White
White
(Neutral wire)
Black
Blue
(Light kit wire)
9
Step 9
Thread steel cable through cable clasp
(S13). Loop wire over and thread back
through cable clasp, making sure loop is
large enough to attach on to "J hook
(S10) in outlet box. Tighten screw
securely to ensure that loop does not
come loose.
Cable Clasp (S13)
Downrod Ground
(Green)
