page 9
wall control
faceplate
(almond
or white)
I
II
IV
VI
III
V
OFF
ON
SET button
faceplate
(black)
handheld
remote control
I
II
IV
VI
III
V
OFF
ON
SET button
diagram 1
13. Automated Learning Process./Activating Code.
CAUTION
:
The wall and/or handheld remote
control can be programmed to multiple receivers or
fans. If this is not desired, turn wall switch off to any
other programmable receiver or fan.
Restore electrical power and then, if using wall
control, set slider switch on wall control to the
ON position. Within 60 seconds of turning on
the wall control, press and hold the fan
SET
button on the wall control for 5 seconds or until
light blinks twice.
Turn power off again for at least 5 seconds
and
then turn power back on. Within 60 seconds of
restoring the power, press and hold the fan
SET
button on the handheld remote control for
5 seconds or until light blinks twice.
Test the light and fan functions to confirm the
learning process is complete--
see Section 15 on
the following page.
Select a faceplate (
almond or white
) and press
firmly onto front of wall control that was
previously installed to the outlet box on the wall.
[
Refer to
diagram 1
.
]
Attach
black faceplate
to front of handheld
remote control; press down firmly.
[
Refer to
diagram 2
.
]
CAUTION
: Store the handheld remote control
away from excess heat or humidity. To prevent
damage to handheld remote control, remove the
battery if remote control will not be used for long
periods.
CAUTION
: “DO NOT DISPOSE OF BATTERIES IN
FIRE, BATTERIES MAY EXPLODE OR LEAK.” - When
disposing of household alkaline batteries, it is
best to check with your local and state recycling
or household hazardous waste coordinators
concerning the specifics of the program in your
area. You may also locate a recycling center by
calling 1-800-8-BATTERY or 1-877-2-RECYCLE or
visit www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING
:
Choking Hazard
- Small parts. Keep
battery away from children.
diagram 2
