Setting Frequency Switches
The remote control unit is operated by a set of frequency switches and
are preset at the factory. The switches are located on the back of the
remote control unit and in the top motor housing of the fan on the
receiving module. The switches can be set in any position as long as both
the wall unit and receiving module switches are set the same. All (RF)
modules & Transmitters come from the factory with the dip switches set
in the (ON) position.
To replace battery, simply push down on tab and slide housing cover off.
Snap 9-Volt battery onto wire terminal and replace into remote housing.
Slide housing cover back onto remote control unit.
1 2 3 4
ON
Remote
Control Unit
Battery
Terminal
PUSH
Housing
Cover
1 2 3 4
ON
Remote
Housing
Operation Instructions
HIGH
Controls fan motor speed. To select desired speed,
MEDIUM
press button once and release
LOW
REVERSE
Controls direction of fan blades. To reverse fan blades, press
once and release.
FAN OFF
Turns fan motor speed off. Press once to turn off. To start
motor speed again, hit one of the motor speed buttons.
L-1
Controls the on/off and intensity for
side body lighting (if
applicable)
. Push and release for on/off function. Hold down
for full range light dimming.
L-2
Controls the on/off and intensity for the
integrated bottom
light kit.
Push and release for on/off function. Hold down for
full range light dimming.
NOTE:
The "High", "Medium" or "Low" buttons may be used to start
the fan motor. The speed of the fan may be changed at any
time.
