Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause
serious injury or death. Do not allow children
to operate the door push button(s) or remote
control(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
Models with 3-function remote controls:
The
remote controls have been factory set to operate
with the
large push button on the remote control.
However, you can use either of the two small
buttons, if you prefer. And, the 3-function remote
control can also activate additional garage door
openers and/or light controls.
Below are instructions for programming your opener
to match the other buttons on your remote controls
and any additional remote controls you may
purchase. See available accessories on page 38.
33
Your garage door opener will learn and respond to
up to 6 transmitter codes:
A. Up to 4 "SRT" portable remote controls, Item
Nos. 18305, 18760, or 18761.
B. One 390MHz, 19,683 code remote control, Item
Nos. 18778 or 18779.
C. One Keyless Entry, Item No. 18775.
To Add A Remote Control
1. Press and
hold the selected remote control push
button, see Figure 1.
2. Then press and release the "SRT" button on the
right side panel of the opener, Figure 2. The
opener lights will
flash once.
3. Release the remote push button.
Now the opener will operate when the remote
control push button is pressed.
If you release the remote control push button
before the opener lights flash, the opener will
not accept the code.
To Change the Selected Push Button
On the Same Remote control
If you decide to use a different remote control
button than originally programmed into the opener,
you must erase
all the learned codes and
reprogram each remote control used to operate the
garage door opener.
To Erase All Remote Control Codes
• Press and hold the "SRT" button on the opener
panel until the indicator light turns off (about 6
seconds).
All the codes the opener has learned
will be erased.
• To reprogram, repeat Steps 1 – 3 for each remote
control in use.
Select a remote control push
button to operate opener
COMPACT 3-FUNCTION
REMOTE CONTROL
3-FUNCTION
REMOTE CONTROL
Setting/Changing Your Code In Receiver(s) and Transmitters
Sears (Canadian/English) Models 139.18778
9/20/90
Garage Door Opener
(With "SRT" Button)
"SRT"
Button
Indicator
Light
END PANEL
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
Ouvre-porte de garage
(avec bouton "SRT")
Bouton
"SRT"
Témoin
PANNEAU ARRIÈRE
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
18800 Series Garage Door Openers
(With "SRT" Button)
Code programming instructions are also located
on the opener panel.
WARNING
CAUTION
WARNING
WARNING
Figure 1
Figure 2
Receiver and Remote Control Programming
To comply with FCC/IC rules, adjustment or modifications of this receiver
and/or transmitter are prohibited, except for changing the code setting or
replacing the battery. THERE ARE NO OTHER USER SERVICEABLE
PARTS.
