14
ASSEMBLY cont.
ALWAYS inspect the sandpaper before installing. DO NOT use if broken or defective.
WARNING:
Failure to unplug the sander could result in accidental starting
causing possible serious personal injury.
!
1. Unplug the sander.
2. If replacing sandpaper, remove old sandpaper.
3.
Two paper clamp levers are located on each side of the sander and are locked into
a slot on top of the platen (see Fig. 3).
4. Raise these two levers “UP” and disengage them from the slots in the platen.
This will release the tension on the paper clamps located at the front and back of the sander
that hold the paper in position on the cushion (see Fig. 3a).
5. Remove old paper.
6. Insert front end of a new sheet of paper approximately 1/2-inch under the front paper clamp
(see Fig. 3b).
7. Lift up on the lever that controls the front paper clamp and lock it back into the slot on the
platen. This will securely clamp the paper to the front of the sander’s cushion.
8. Smooth out the sheet of paper by pressing it tightly against the bottom of the cushion
(front to back).
9. Insert back end of paper approximately 1/2-inch under the paper clamp located at the back
of the sander.
10. Lift up on the lever that controls the paper clamp located at the back of the sander and lock it
back into the slot on the platen. This will securely clamp the paper to the back of the sander’s
cushion.
The sandpaper should now be positioned tightly against the cushion from front to back,
securely clamped in place.
Fig 3a
Fig 3b
NOTE: Remove dust bag assembly when installing non-adhesive and/or pressure
sensitive adhesive-backed paper. ALWAYS remember to reattach the dust bag
assembly before beginning sanding operation (see pages 16, Fig. 6).
NOTE: ALWAYS be sure that both paper clamp levers are in the locked position on
the platen and both paper clamps have the sandpaper securely clamped to the bottom
of the cushion before starting sanding operation.
Installing Non-Adhesive Sandpaper (See Figs. 3 , 3a and 3b)
Paper Goes
Under Clamp
Clamp
Move lever
down to
raise clamp
Raise lever
up to clamp
paper
