ASSEMBLY
Figure 2
Figure 3
Figure 4
aTTaCHing THe HanDLe
Remove the hairpin clips from the handle brackets and remove
the carriage screws and wing nuts from the lower handle.
Place the bottom holes in lower handle over the pins on the
handle brackets and secure with hairpin clips. See Figure 2.
Insert carriage screws through upper hole in lower handle
from the inside and secure with wing nuts. See Figure 2.
2. a. Unfold the upper handle until it aligns with lower handle.
Make sure the rope guide is on the right side of upper handle.
See Figure 3.
IMPORTANT
: Make sure the cables are routed outside the lower
handle. Also, do not crimp the cables while lifting up the handles.
b. Secure the two handles by tightening the star knobs
(carriage bolts must be seated properly into the handle). See
Figure 3.
3. Loosen the wing nut that secures the rope guide to the right side
of upper handle.
a. Pull the starter rope out of the engine slowly. See Figure 4.
b. Slip the starter rope into the rope guide.
c. Tighten the wing nut. See Figure 4.
1.
a.
b.
A
B
A
B
C
Summary of Contents for 247.77012
Page 6: ...This page left intentionally blank ...
Page 59: ...59 NOTAS ...
