23
SERVICE AND MAINTENANCE
Figure 32
interval
item
service
service Log
Each Use and every 5
hours
Engine oil level
1.
Loose or missing hardware
2.
Unit and engine.
3.
Check
1.
Tighten or replace
2.
Clean
3.
1st 5 hours
Engine oil
1.
Change
1.
Annually or 25 hours
Spark plug
1.
Control linkages and pivots
2.
Wheels
3.
Gear shaft and Auger shaft
4.
Check
1.
Lube with light oil
2.
Lube with multipurpose auto grease
3.
Lube with light oil
4.
Annually or 50 hours
Engine oil
1.
Change
1.
Annually or 100 hours
Spark plug
1.
Change
1.
Before Storage
Fuel system
1.
Run engine until it stops from lack
1.
of fuel
Warning
Before performing any type of maintenance/service, disengage all
controls and stop the engine. Wait until all moving parts have come to
a complete stop. Disconnect spark plug wire and ground it against the
engine to prevent unintended starting. Always wear safety glasses during
operation or while performing any adjustments or repairs.
Follow the maintenance schedule given below. This chart describes
service guidelines only. Use the Service Log column to keep track of
completed maintenance tasks.
To locate the nearest Sears Service
Center or to schedule service, simply contact Sears at
1-800-4-MY-HOME®.
maintenanCe sCHedULe
NOTE:
If you’re replacing the friction wheel assembly as a whole,
discard the worn part and slide the new part onto the hex shaft.
Follow the steps above in reverse order to reassemble components. If
you’re disassembling the friction wheel and replacing only the rubber
ring, proceed as follows:
Remove the four screws which secure the friction wheel’s side
1.
plates together. See Figure 32.
Remove the rubber ring from between the plates.
2.
Reassemble the side plates with a new rubber ring.
3.
NOTE
: When reassembling the friction wheel assembly, make sure
that the rubber ring is centered and seated properly between the side
plates. Tighten each screw only one rotation before turning the wheel
clockwise and proceeding with the next screw. Repeat this process
several times to ensure the plates are secured with equal force
(between 6 ft-lbs and 9 ft-lbs).
4. Slide the friction wheel assembly back onto the hex shaft and
follow the steps above in reverse order to reassemble
components.
5. Perform the Drive Control Test outlined earlier in the Service and
Maintenance section.
