11
OPERATION
INSTALLING/REMOVING
SANDING DISC
See Figure 7.
Unplug the sander/polisher.
�
Position the tool as shown in figure 7 and lock the spindle
lock.
�
Center and place the sanding disc over the rubber
disc and start spanner nut onto threaded spindle in a
clockwise direction, into the center of the sanding disc.
�
Securely tighten spanner nut with the spanner wrench
provided.
�
Release the spindle lock.
To remove:
�
Unplug the sander/polisher.
�
Position the tool as shown in figure 7 and lock the
spindle lock.
�
Loosen spanner nut with the spanner wrench provided
by turning counterclockwise.
�
Remove spanner nut.
�
Remove the sanding disk.
�
Release the spindle lock.
NOTE:
A sanding disc is not supplied.
SPINDLE LOCK
See Figure 6.
�
Unplug the sander/polisher.
�
To lock the spindle, depress and hold the spindle lock.
��
While keeping the lock depressed, rotate the disc
clockwise until the spindle clicks into a locked position
and will not rotate further.
�
�To unlock, release the spindle lock.
Fig. 6
SPINDLE
LOCK
INSTALLING/REMOVING RUBBER DISC
See Figures 6.
Unplug the sander/polisher.
Position the tool as shown in figure 6 and lock the
spindle lock.
Thread rubber disc, flat face up, onto spindle in a
clockwise direction. Turn until rubber disc shoulders on
the spindle.
Start spanner nut onto threaded spindle in a clockwise
direction.
Securely tighten spanner nut with the spanner wrench
provided.
Release the spindle lock.
TURN
CLOCKWISE
TO
TIGHTEN
TURN
COUNTERCLOCKWISE
TO
LOOSEN
Fig. 7
RUBBER
DISC
SANDING
DISC
SPANNER
NUT
SPANNER
WRENCH
SPINDLE
LOCK
To remove:
Unplug the sander/polisher.
Position the tool as shown in figure 6 and lock the
spindle lock.
Loosen spanner nut with the spanner wrench provided
by turning counterclockwise.
Remove spanner nut.
Turn rubber disc counterclockwise to remove.
Release the spindle lock.
SPANNER
NUT
SPANNER
WRENCH