WARNING: Read and understand all
instructions.
Failure to follow all
instructions listed below may result in
electric shock, fire and/or serious personal
injury.
SAVE THESE
INSTRUCTIONS
WORK AREA
•
Keep your work area clean and well lit.
Cluttered benches and dark areas invite
accidents.
•
Do not operate power tools in
explosive atmospheres, such as in the
presence of flammable liquids, gases,
or dust.
Power tools create sparks which
may ignite the dust or fumes.
•
Keep bystanders, children, and
visitors away while operating a power
tool.
Distractions can cause you to lose
control.
ELECTRICAL SAFETY
•
Double insulated tools are equipped
with a polarized plug (one blade is
wider than the other.) This plug will fit
in a polarized outlet only one way. If
the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
a polarized outlet. Do not change the
plug in any way
. Double insulation
eliminates the need for the three wire
grounded power cord and grounded
power supply system.
•
Avoid body contact with grounded
surfaces such as pipes, radiators,
ranges and refrigerators.
There is an
increased risk of electric shock if your
body is grounded.
•
Don’t expose power tools to rain or
wet conditions.
Water entering a power
tool will increase the risk of electric
shock.
•
Do not abuse the cord. Never use the
cord to carry the tools or pull the plug
from an outlet. Keep cord away from
heat, oil, sharp edges or moving parts.
Replace damaged cords immediately.
Damaged cords increase the risk of
electric shock.
•
When operating a power tool outside,
use an outdoor extension cord marked
"W-A" or "W."
These cords are rated for
outdoor use and reduce the risk of
electric shock.
PERSONAL SAFETY
•
Stay alert, watch what you are doing
and use common sense when
operating a power tool. Do not use tool
while tired or under the influence of
drugs, alcohol, or medication.
A
moment of inattention while operating
power tools may result in serious personal
injury.
•
Dress properly. Do not wear loose
clothing or jewelry. Contain long hair.
Keep your hair, clothing, and gloves
away from moving parts.
Loose
clothing, jewelry, or long hair can be
caught in moving parts. Air vents cover
moving parts and should be avoided.
•
Avoid accidental starting. Be sure
switch is off before plugging in.
Carrying tools with your finger on the
switch or plugging in tools that have the
switch on invites accidents.
•
Remove adjusting keys or wrenches
before turning the tool on.
A wrench or
key that is left attached to a rotating part
of the tool may result in personal injury.
•
Do not overreach. Keep proper footing
and balance at all times.
Proper footing
and balance enables better control of the
tool in unexpected situations.
•
Use safety equipment. Always wear
2
GENERAL SAFETY RULES
ONE YEAR FULL WARRANTY ON CRAFTSMAN TOOL
If this Craftsman tool fails to give complete satisfaction within one year from date of
purchase, RETURN IT TO THE NEAREST SEARS STORE IN THE UNITED STATES,
and Sears will replace it, free of charge.
If this Craftsman tool is used for commercial or rental purposes, this warranty applies
for only 90 days from the date of purchase.
This warranty gives you specific legal rights, and you may also have other rights which
vary from state to state.
SEARS, ROEBUCK AND CO., DEPT. 817WA, HOFFMAN ESTATES, IL 60179
SEARS WARRANTY
479218-00 01 11647 Searsnewone 4/12/07 8:15 AM Page 2
