46
OPERACIÓN
Estos símbolos pueden aparecer sobre su tractor o en la literatura proporcionada con el producto.
Aprenda y comprenda sus significados.
RÁPIDO
LENTO
MARCHA
ATRÁS
NEUTRO
ALTO
BAJO
MARCHA
ATRÁS
MARCHA
HACIA
ADELANTE
COMBUS-
TIBLE
MOTOR
APAGADO
ALTURA
DE LA
SEGADORA
MOTOR
ENCENDIDO
MOTOR
EN MARCHA
BATERÍA
LEVANTA-
MIENTO DE
LA SEGADORA
SISTEMA
FUNCIONAMIENTO
ATRÁS (ROS)
LUCES
ENSENDIDAS
PEDAL DE
FRENO /
EMBRAGUE
PALANCA DE
MANDO CRUCERO
FRENO DE
ESTACION-
AMIENTO
RUEDA LIBRE
(Solamente para los
modelos automatico)
No seguir las siguientes
instrucciones puede provocar
heridas o muerte. Los símbolos
de aviso de seguridadse utilizan
para identificar informaciones de
seguridad relativas a peligros que
pueden provocar la muerte, heridas
graves y/o daños a la máquina.
PELIGRO
indica un peligro que, si no se evita,
provoca muerte o lesiones graves.
ADVERTENCIA
indica un peligro que, si no se evita,
puede provocar muerte o lesiones graves.
PRECAUCIÓN
indica un peligro que, si no se evita,
puede provocar lesiones ligeras o moderadas.
PRECAUCIÓN
cuando se utiliza
sin
el símbolo de
aviso, indica una situación que
puede provocar
daños al tractor y/o al motor.
FUEGO
indica un peligro que, si no se evita,
puede
provocar la muerte, lesiones graves y/o danos
a la máquina.
SUPERFICIES CALIENTES
indica un peligro que,
si no se evita,
puede provocar la muerte, lesiones
graves y/o danos a la máquina.
EL CIERRE
DIFERENCIAL
PROTECCIÓN
DE OÍDO SE
REQUIERE
PELIGRO, GUARDE
LAS MANOS Y
LOS PIES LEJOS
15
15
MANTENGA EL
AREA DESPEJADA
PELIGROS DE
PENDIENTES
(VEA LA SECCIÓN DE LAS REGLAS DE SEGURIDAD)
ACCESORIO
DEL EMBRAGUE
ENGANCHADO
ACCESORIO
DEL EMBRAGUE
DESENGANCHADO
POSICIÓN DE ARRANQUE
EN CLIMA FRÍO
INTERRUPTOR
DE ARRANQUE
SmartSwitch™
31
02603
Keps
Nut
Positive
(Red)
Cable
Negative (Black)
Cable
Hex
Bolt
Terminal
Cover
2. Disconnect BLACK battery cable first then
RED battery cable and carefully remove
battery from trac tor.
3. Install new battery with terminals in same
position as old battery.
4. First connect RED battery cable to posi-
tive (+) terminal with hex bolt and keps
nut as shown. Tighten securely. Slide
terminal cover over terminal
5. Connect BLACK grounding cable to
negative (-) ter mi nal with remaining hex
bolt and keps nut. Tighten se cure ly.
Seat pan
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Remove bulb hold
er from the hole in the
back side of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in the
backside of the grill.
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
• Check wiring.
TO REPLACE FUSE
Replace with 20 amp automotive-type plug-
in fuse. The fuse holder is located behind
the dash.
S
MART
S
WITCH
IGNITION SYSTEM
LIGHTS
The SmartSwitch System is equipped with
courtesy lights that are used to indicate
system functions or faults.
FUNCTIONS
• The SmartSwitch Ignition (SSI) Button
(F) will blink blue while waiting for the
correct passcode to be entered. The
SSI button will blink green when tractor
is ready to start and remain solid green
while running.
• The park brake symbol (CC) will be lit if
the parking brake has not been engaged
during a start attempt.
• The blade switch symbol will blink if the
attachment clutch control is not in the
"DISENGAGED" position during a start
attempt.
• The Reverse Operation System (ROS)
button (G) will be lit when Reverse Op-
eration System is in use.
• The Headlight button (H) will remain lit
while headlights are in use.
• During normal operation, the Battery
Indicator button (I) will not be lit.
FAULTS
• The SSI Button will blink red for two
seconds if the wrong passcode has been
entered.
• The Reverse Operation System (ROS)
button will blink when there is a fault
with the Reverse Operation System.
See "Reverse Operation System" in the
Operation section of this manual.
• After the first unsuccessful start attempt,
the battery indicator button (I) will blink
for two (2) seconds and then stay lit. This
indicates that the battery voltage is below
normal operating level. While engine is
in operation, this light may also indicate
a charging system failure.
• The headlight button will blink when one
or both of the headlight bulbs fail.
• All indicator lights will blink in the event
the engine shuts off for unknown reasons;
for example, if the engine has run out of
fuel.
F
G
H
I
CC
EE
