Craftsman 919.727350, Owner'S Manual

6 — ENG

D20418    Rev. 0    2/22/00

brushes, and inflator kits. An air pressure regulator is
required for most of the applications.

An inline air filter which removes moisture and dirt from
compressed air should be used where applicable.

An inline regulator can be used if a more precise
adjustment of air pressure is needed downstream.

CFM: 

 Cubic Feet per Minute.

SCFM: 

 Standard Cubic Feet per Minute; a unit of mea-

sure of air delivery.

PSI: 

 Pounds per Square Inch; a unit of measure of pres-

sure.

ASME: 

 American Society of Mechanical Engineers;

made, tested, inspected and registered to meet the stan-
dards of the ASME.

Cut-In Pressure: 

 While the motor is off, air tank pres-

sure drops as you continue to use your accessory. When
the tank pressure drops to a certain low level and the
pressure switch lever is in "Auto",  the motor will restart
automatically.  The low pressure at which the motor au-
tomatically restarts is called “cut-in pressure.”

You have purchased an air compressor unit consisting
of a one cylinder, single-stage air compressor pump
and air tank. Included are wheels, regulator, gauges,
and handle.

This air compressor requires no oil.  Now you can
enjoy all the benefits of having an air compressor
without ever having to purchase, add or change oil.

Your air compressor can be used for operating paint
spray guns, air tools, blow guns,  nailers/staplers, air

Model No.

Bore
Stroke
Voltage - Single Phase
Minimum Branch Circuit Requirement
Fuse Type
Amperage at Maximum Pressure
Air Tank/Capacity
Approximate Cut-in Pressure
Approximate Cut-out Pressure
SCFM @ 40 psi
SCFM @ 90 psi

919.727350

2 3/8"

1.35"

120

15 amps

Time Delay

15.0

ASME/30 gal. (U.S.)

100
130

7.8
5.5

Cut-Out Pressure: 

 When you turn on your air com-

pressor and it begins to run, air pressure in the air tank
begins to build.  It builds to a certain high pressure be-
fore the motor automatically shuts off - protecting your
air tank from pressure higher than its capacity.  The high
pressure at which the motor shuts off is called “cut-out
pressure.”

CSA:

  Electrical products sold in Canada are required to

be certified to the applicable CSA standard (s). Cana-
dian Standards Association (CSA) is a standards writing
and safety testing organization. Products that are CSA
certified have been evaluated and tested and found to
meet or exceed the applicable CSA standard (s) for safety
and electrical performance.

GENERAL INFORMATION

GLOSSARY

SPECIFICATION  CHART