6
• To select reverse, depress the forward/reverse control button to the right (as viewed from rear of tool).
NOTe:
When changing the position of the control button, be sure the trigger is released.
INSTAllING AND ReMOvING TOOl ATTAChMeNTS - fIGURe A
WARNING
:
Shock hazard.
Under no circumstances should
this product be used near water.
WARNING:
Burn hazard.
Moving parts within the Power Unit
become hot during use. Avoid contact with moving parts within
Power Unit when removing and installing accessories.
WARNING
:
To reduce the risk of injury
,
turn off and unplug
the tool before making any adjustments or removing or installing
attachments or accessories. Remove any accessory from the tool
attachment before removing or installing the attachment.
• To remove an attachment, depress the release button (4) and take
the attachment off the tool.
• To fit an attachment, line it up with the tool as shown and push it onto the Power Unit until it snaps
into place and an audible click is heard.
• Ensure that attachment is securely attached by gently pulling on it in the opposite direction from the
Power Unit.
NOTe:
Only use attachments that are specifically designed for and compatible with the Power Unit.
NOTe:
Refer to individual attachment instruction manuals for specific safety warnings and operating
instructions before operating attachments with the Power Unit.
WARNING:
To reduce the risk of injury
,
do not place fingers or any other object inside the
Power Unit, other than the attachments designed to work with the Power Unit.
OPeRATING: DRIll/SCReWDRIveR ATTAChMeNT
SAfeTy WARNINGS AND INSTRUCTIONS: DRIllS
1. Hold drill firmly with one hand on the grip unless an auxillary handle has been supplied with the
tool. Use auxillary handle if supplied with the tool.
2. When attaching accessories in the drill chuck, hand tighten the keyless chuck firmly.
WARNING:
Drill may stall (if overloaded or improperly used) causing a twist. Always expect the
stall. Grip the drill firmly with both hands to control the twisting action and prevent loss of control which
could cause personal injury. If a stall does occur, release the trigger immediately and determine the
reason for the stall before re-starting.
WARNING:
Let the tool work at its own pace. Do not overload.
WARNING:
Before drilling into walls, floors or ceilings, check for the location of wiring and pipes.
WARNING:
To reduce the risk of injury,
always unplug drill from power supply before making
any adjustments or changing accessories.
fITTING AND ReMOvING A DRIll BIT OR SCReWDRIveR BIT
The drill/screwdriver attachment (5) is fitted with a keyless chuck (6) to allow for an easy exchange of bits.
• Unplug the Power Unit before installing or removing accessories.
• Open the chuck by turning the front part clockwise with one hand while holding the rear part with
the other.
• Insert the bit shaft into the chuck.
• Firmly tighten the chuck by turning the front part counterclockwise.
A
Summary of Contents for Bolt-On 35592
Page 16: ......