10
ASSEMBLY
WARNING
Always keep hands and feet clear of equipment moving parts. Do not
use a pressurized starting fluid. Vapors are flammable.
1. Remove the gas cap, check the fuel level and add fuel if necessary.
Fill the tank until the fuel reaches 1/2” below the bottom of the filler
neck to allow for fuel expansion. Be careful not to overfill.
Checking and Adding Oil
CAUTION
The engine is shipped without oil in the engine. You must fill the
engine with oil before operating. Running the engine with insufficient
oil can cause serious engine damage and void the product warranty.
1. Place the snow thrower on a flat, level surface.
2. Remove the oil filler cap/dipstick and wipe the dipstick clean. See
Figure 11.
3. Insert the cap/dipstick into the oil filler neck, but do not screw it in.
4. Remove the oil filler cap/dipstick. If the level is low, slowly add oil
until oil level registers between high (H) and low (L), Figure 11.
NOTE:
Do not overfill. Overfilling with oil may cause smoking, hard
starting, or spark plug fouling.
5. Replace and tighten cap/dipstick firmly before starting engine.
NOTE:
DO NOT allow oil level to fall below the “L” mark on the
dipstick. Doing so may result in equipment malfunctions or damage.
NOTE:
To change the oil on your engine, see the Maintenance
Section of this manual.
Fill
between
the high
and low
marks
Oil Filler Cap/
Dipstick
Figure 11
