11
OPERATION
Now that you have set up your snow thrower, it’s important to become
acquainted with its controls and features. Refer to Figure 19.
SHIFT LEVER
The shift lever is located on the right side of the handle panel.
Place the shift lever into any of eight positions to control the
direction of travel and ground speed.
Forward
Your snow thrower has six forward (F) speeds. Position one (1) is
the slowest and position six (6) is the fastest.
Reverse
Your snow thrower has two reverse (R) speeds. One (1) is the
slower and two (2) is the faster.
DRIFT CUTTERS
(if so equipped)
The drift cutters are designed for use in deep snow. Their use is
optional for normal snow conditions. Maneuver the snow thrower so
that the cutters penetrate a high standing snow drift to assist snow
falling into the augers for throwing.
SKID SHOES
Position the skid shoes based on surface conditions. Adjust upward
for hard-packed snow. Adjust downward when operating on gravel or
crushed rock surfaces.
KEY
The key is a safety device. It must be fully inserted in order for the
engine to start. Remove the key when the snow thrower is not in use.
NOTE
: Do not turn the key in an attempt to start the engine. Doing so
may cause it to break.
CHOKE CONTROL
The choke control is found on the rear of the engine and is activated
by turning the rotary choke knob to the CHOKE position. Activating
the choke control closes the choke plate on the carburetor and aids in
starting the engine.
PRIMER
Depressing the primer forces fuel directly into the engine’s carburetor
to aid in cold-weather starting.
OIL FILL
Engine oil level can be checked and oil added through the oil fill.
GAS CAP
Unthread the gas cap to add gasoline to the fuel tank.
Figure 19
Drive Control
Chute Assembly
Gas Cap
Headlight
Shift Lever
Four-Way Chute Control™ (Joystick)
Auger Control
Clean Out
Tool
Augers
Skid Shoe
Wheel Steering Control
Heated Grips
Drift Cutters
Oil Drain
Electric Starter Outlet
Primer
Throttle
Control
Choke
Control
Electric
Starter
Button
Recoil Starter
Handle
Key
Oil Fill
Summary of Contents for C459-52310
Page 26: ...26 A B Models w heated grips ...