4
7.
Slide control rod crank through hole in handle panel and
into control rod universal joint (
P
).
8.
Secure with hair pin (
Q
).
9.
Visually check for gear mesh between worm and ring
gears. There should be a small amount of backlash to
prevent binding (
R
).
10.
Loosen the adjustment nut (
S
).
11.
Slide the worm gear assembly closer to or farther from
the ring gear until there is a small amount of gap between
the gear teeth (
T
).
12.
Tighten the adjustment nut to 15 lb-ft (20 Nm) (
U
).
13.
Install gear assembly cover and tighten nut securely (
V
).
7
8
Q
P
15 lb-ft
(20 Nm)
9
10
11
13
12
1/2˝
R
U
S
V
T
