English
8
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from power
source and remove the battery pack before
making any adjustments or removing/installing
attachments or accessories.
An accidental start-up
start up can cause injury.
Accessories
WARNING:
Since accessories, other than those
offered by CRAFTSMAN,
have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call
1-888-331-4569
.
Versatrack Variables
1ST_Figure
1ST_Callout
2ND_Callout
H
8
12
Versatrack™ (Fig. H)
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from power
source and remove the battery pack before
making any adjustments or removing/installing
attachments or accessories.
An accidental start-up
start up can cause injury
WARNING:
To reduce the risk of serious personal
injury, do not use a damaged Versatrack hang hook or
Versatrack™ Trackwall. A damaged Versatrack™ hang
hook or Versatrack™ Trackwall will not support the
weight of the tool.
Fig. E
5
11
Screw Threads (Fig. E)
1. Place the mounting base
5
of the light on the tripod's
mounting screw using a screw with a 1/4" bolt, and
20 threads per inch.
2. Rotate the area light clockwise to attach.
Keyhole Slots (Fig. E)
If using the keyhole slots
11
, use at least 2 screws, one on
each side, secured into a sturdy surface.
1. Place the wide portion of the keyhole slot over the head
of the screw.
2. Slide the area light down until the screw is inside the
narrow portion of the keyhole and check to be sure the
light is secure.
Light Levels (Fig. A)
The area light has 2 brightness levels. Continue to press the
on/off switch
1
to cycle from OFF-HI-LO brightnesses.
On/Off Switch (Fig. A)
CAUTION: Do not stare into area light lens.
Serious eye injury could result.
To turn the area light on, press the on/off switch
1
.
To turn the area light off, press the on/off switch until the
light goes out.
Pivoting the Light Housing (Fig. F)
The area light housing
3
can be pivoted to different
positions within the 360° pivot range.
1. To pivot the area light housing first loosen the pivot
nut
6
.
2. Rotate the area light housing to your desired position.
Tighten the pivot nut.
3
Fig. F
6
AC Outlet/AC Plug (Fig. G)
The area light can be powered by battery or 120V AC.
1. First remove battery from battery slot
7
.
2. Fit an extension cord into the AC plug
2
then into a
wall outlet to power the area light.
Fig. G
2
7
