English
7
Fig. C
18
11
12
35
Side Discharge (Fig. A)
DANGER:
Remove safety key and battery pack before
removing collection bag.
1. To operate mower in side discharge mode remove the
grass collection bag.
2. Be sure rear door cover
11
is down for side discharge.
3. Lift the side flap
16
and hook side discharge
attachment
17
onto the mower.
4. Release the side flap and ensure the attachment holds
in place before turning mower on.
nOTE:
The rear door cover is shaped in such a way that
the opening (at the bottom) cannot be completely
closed off.
OPERATION
DANGER: To reduce the risk of serious personal
injury, turn unit off, remove safety key, and
remove battery pack before making any
adjustments or removing/installing attachments
or accessories.
An accidental start-up can
cause injury.
Installing and Removing the Battery Pack
(Fig. A, D)
DANGER:
MAKE CERTAIN THE SAFETY KEY IS
REMOVED TO PREVENT ACTUATION BEFORE
REMOVING OR INSTALLING BATTERY.
nOTE:
For best results, make sure the battery pack is
fully charged.
To Install Battery Pack
1. Lift and hold the battery port cover
9
up to expose the
battery port
19
.
2. Slide a battery pack
20
into the battery port until an
audible click is heard (Fig. D). Make sure the battery pack
is fully seated and fully latched into position.
3. Close the battery port cover. Ensure the cover is fully
closed before starting mower.
To Remove Battery Pack
1. Open the battery port cover
9
as described above.
ASSEMBLY
DANGER: To reduce the risk of serious personal
injury, turn unit off, remove safety key, and
remove battery pack before assembly, making
any adjustments or removing/installing
attachments or accessories.
An accidental start-up
can cause injury.
Adjusting Handle Height (Fig. B)
The mower is shipped in storage mode. You will need to
adjust the handle to operating position before continuing.
1. To unlock the handle
4
from storage position, twist the
two handle locks
6
90°. The handle locks are located on
both sides of the handle as shown in Fig. B.
2. Raise the handle to operating position.
3. Locate the three handle detent holes
34
located on
the handle brackets
7
as shown in Fig. B.
4. Adjust the handle to the position that best fits the
operator and lock the handle in place by twisting the
handle locks back 90° and allowing the handle locks
6
to snap into the desired detent holes.
Fig. B
6
4
34
7
Grass Collection Bag (Fig. C)
DANGER:
Remove safety key and battery pack, when
opening rear door cover and installing bag.
1. Lift the rear door cover
11
and place the grass
collection bag
12
onto the mower so the bag
hooks
35
rest on the lugs
18
as shown in Fig. C. Then
lower the rear door cover.
DO nOT
use under wet conditions or in presence of
flammable liquids or gases.
DO nOT
let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.