11
English
MAINTENANCE
WARNING:
To reduce the risk of
serious personal injury, turn unit off and
remove the battery pack before making any
adjustments or removing/installing attachments
or accessories, when replacing line, or prior to
cleaning.
An accidental start-up can cause injury.
nOTE:
Hand wound spools from bulk line are likely to
become tangled more frequently than CRAFTSMAN factory
wound spools. For best results, factory wound spools are
recommended.
1. Remove battery from appliance.
2. Remove the empty spool from the appliance as
described in
Replacing Spool Assembly
.
3. Remove any remaining cutting line from the spool.
4. Make a fold at the end of the cutting line at about 3/4"
(19 mm)
25
. Feed the cutting line into one of the line
anchoring slots
26
.
5. Insert the 3/4" (19 mm) end of the bulk line into the
hole
27
in the spool adjacent to the slot. Make sure the
line is pulled tight against the spool.
6. Wind the cutting line onto the spool in the direction of
the arrow on the spool. Make sure to wind the line on
neatly and in layers. Do not crisscross.
7. When the wound cutting line reaches the recesses
28
cut the line.
8. Fit the spool onto the appliance as described in
Replacing Spool Assembly
.
Fig.K
26
25
27
28
Fig. L
Versatrack™ (Fig. M)
WARNING:
To reduce the risk of
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories.
An accidental start-up can cause injury.
WARNING:
To reduce the risk of serious
personal injury, do not use a damaged Versatrack™
integral hang hook or Versatrack™ Trackwall.
A damaged Versatrack™ integral hang hook or
Versatrack™ Trackwall will not support the weight of
the tool.
WARNING:
To reduce the risk of serious
personal injury, DO NOT suspend tool overhead or
suspend objects from the integral hang hook. ONLY
suspend tool on the Versatrack™ Trackwall using the
integral hang hook.
WARNING:
The Versatrack™ integral
hang hook is intended to mount the tool onto a
Versatrack™ Trackwall rail. Do not use the integral
hang hook to mount the tool to any other surface.
WARNING:
The Versatrack™ integral
hang hook is not a belt hook.
WARNING:
When hanging objects on a
Versatrack™ Trackwall rail, adequately space the tools
in order to not exceed 75 lb (35 kg) per linear foot.
WARNING:
Before using the tool make
sure that the Versatrack™ integral hang hook is
returned to its original position
iMPORTAnT:
Versatrack™ accessories mount compatible
tools securely to the Versatrack™ Trackwall system.
1. Turn tool off, remove the battery pack and
remove accessories.
CAUTION:
Any product with exposed
cutting teeth must have them covered securely if it is
to be on the Versatrack™ Trackwall.
2. Mount the integral hang hook
29
to the
Versatrack™ Trackwall.
Accessories
WARNING:
Since accessories, other than
those offered by CRAFTSMAN,
have not been tested
with this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call
1-888-331-4569
.
