English
9
TROUBLESHOOTING
For assistance with your product, visit our website
www.craftsman.com
for the location of the service center nearest
you or call the Craftsmanhelp line at:
888-331-4569.
PROBLEM
SOLUTION
Trimmer runs slowly.
Unplug trimmer.
Check that the spool housing can rotate freely. Carefully clean it
if necessary.
Check that the cutting line does not protrude more than approximately
4-13/16 inches (122 mm) from the spool. If it does, cut it off so that it just
reaches the line trimmingblade.
Trimmer will not start.
Plug trimmer into a working outlet.
Replace circuit fuse. (If the product repeatedly causes the circuit fuse to
blow, discontinue use immediately and call the Craftsman help line at
888-331-4569.)
Call the Craftsman help line at 888-331-4569 to have cord or
switch replaced.
Overfeeding
Make sure you are using 0.065 inch (1.65 mm) diameter ROUND line.
Ensure you are cutting with the tip of the line (7 inches (177.8 mm) from the
spool).Use the edge guide if needed to ensure proper space is maintained.
Ensure you are not exceeding a 10° angle.
Line unravels when cap or spool is removed.
Make sure to park the lines in holding slots (Figure S) before removing.
