English
8
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove air supply before
making any adjustments or removing/installing
attachments or accessories.
An accidental
actuation can cause injury.
Accessories
WARNING:
Since accessories, other than those
offered by CRAFTSMAN,
have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call
1-888-331-4569
.
Versatrack™ (Fig. J)
WARNING:
To reduce the risk of serious personal
injury, turn unit off and remove air supply before
making any adjustments or removing/installing
attachments or accessories.
An accidental
actuation can cause injury.
WARNING:
To reduce the risk of serious personal
injury, do not use a damaged Versatrack™ hang hook
or Versatrack™ Trackwall. A damaged Versatrack™
hang hook or Versatrack™ Trackwall will not support
the weight of the tool.
WARNING:
To reduce the risk of serious personal
injury, ensure the fitting holding the hang hook
is secure.
WARNING:
To reduce the risk of serious personal
injury, DO NOT suspend tool overhead or suspend
objects from the hang hook. ONLY suspend tool on the
Versatrack™ Trackwall using the hang hook.
WARNING:
Ensure that the tool weight does not
exceed the maximum rated weight for the selected
Versatrack™ hook.
WARNING:
When hanging objects on a Versatrack™
Trackwall rail, adequately space the tools in order to
not exceed 75 lb (35 kg) per linear foot.
iMPORTAnT:
Versatrack™ accessories mount compatible
tools securely to the Versatrack™ Trackwall system.
1. Turn tool off, remove air supply and remove accessories.
CAUTION:
Any product with exposed cutting teeth
must have them covered securely if it is to be on
the Versatrack™ Trackwall.
2. Attach the hang hook
15
on the tool.
a. Use a wrench to remove the fitting
5
.
b. Place the Versatrack™ hang hook on the fitting.
c. Use a wrench to re-install the fitting at the base of
the tool.
nOTE:
Versatrack™ accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call
1-888-331-4569
.
Fig. J
5
15
Versatrack Variables
1ST_Figure
1ST_Callout
2ND_Callout
J
15
5
Belt Hook (Fig. A)
WARNING:
Never use belt hook with bump action
trigger installed on tool.
The nailers include an integrated belt hook
4
and can be
hooked to either side of the tool to accommodate left or
right handed users.
If the hook is not desired at all, it can be removed from
the tool.
To Remove Belt Hook
1. Disconnect the tool from the air supply.
2. Lift the lever and slowly move the belt hook to the
direction of the trigger.
3. Using the appropriate hex wrench, remove the end cap
screws from the end cap of the tool.
4. Remove the belt hook.
5. Replace end cap and gasket. Ensure that the three
screws are tight.
6. Replace and tighten air fitting.
6. Turn pressure up to operating level (not to exceed
120 p.s.i.g. [8 kg/cm
2
]) and use tool as normal.
7. Always drain the compressor tanks at least once a day.
Hot Weather Operation
Tool should operate normally. However, keep tool out
of direct sunlight as excessive heat can deteriorate
bumpers, o-rings and other rubber parts resulting in
increased maintenance.
