Craftsman CMXCAFG190643, Instruction Manual

3

English

OPERATING THE SPRAYER

Filling
Fill the tank to the desired level.
1a. REMOVE PUMP: Turn handle counter-clockwise
2a. INSTALL PUMP: Turn handle clockwise until tightly sealed   
      on tank

Pressurizing
Make sure the shut-off trigger is not locked  in the “in use” 
position
1b. Push down on the handle and turn counter-clockwise to 
      unlock the handle.
2b. Pump handle in a smooth up and down motion until 
      pressure builds up.
3b. Push down on handle, turn clockwise to lock into place.

Spraying and Locking
1. Squeeze shut-off trigger to begin spraying.
2. Release shut-off trigger to stop spraying.
3. For continuous spraying, squeeze the trigger and slide  
    into locked position as shown.

Finish

1.  Depressurize

a.  Lay tank on its side with the hose outlet on the 

bottom. Direct nozzle away from face and body and 
squeeze the shut-off handle until unit stops spraying. 
This will release the pressure in the tank.

2.  Turn the pump handle counter-clockwise to remove 

pump.

3.  Empty any remaining liquid according to the product 

disposal directions.

4.  Follow cleaning instructions.

Cleaning

1.  Fill the tank with clean tap water. Replace the pump 

and tighten securely.

2.  Agitate the tank to rinse the chemicals from the tank 

and pump.

3.  Remove the pump and empty the contents according 

to the product disposal instructions.

4.  Refill the tank with clean tap water.
5.  Make sure the pump is free of dirt and debris, and 

re-install into the tank. Tighten securely.

6.  Pressurize the tank as described in the pressurizing 

section.

7.  Direct the nozzle away from yourself and squeeze the 

shut-off trigger for at least 30 seconds to clean the hose 
and shut-off.

8.  Release pressure as described in the finishing section.
9.  Remove the pump and empty contents according to 

the product disposal instructions.

10.  Repeat steps 1-9 until thoroughly cleaned.

Sprayer Storage

1.  Sprayer tank should be hung upside down, with the 

pump removed.

2.  Do not store or leave any solution in tank after use.
3.  Store in warm, dry location out of direct sunlight.
4.  Keep sprayer and all chemicals out of reach of children.

Disassembly & Reassembly

1.  Remove pump from tank.
2.  Squeeze tabs that lock cap and pull to unlock.
3.  Remove handle, lubricate o-ring as required.
4.  Replace pump cap, align tabs on pump cap and barrel, 

and push down until tabs lock into place.

1a

2a

1b

2b

3b