9
English
4. Slide the table with the rack onto the column. (Fig. G)
5. Engage the bottom of the rack
17
with the lip of the
column assembly. Tighten the table lock handle
5
to
lock the table to the column assembly.
nOTE:
Do not overtighten.
6. Install the rack ring
6
onto the column, so the top lip of
the rack sits into the rack ring
6
. (Fig. H)
nOTE:
To avoid column or collar damage, DO NOT
OVERTIGHTEN the set screw
30
.
WARNING:
The bottom of the collar
MUST NOT
be
pushed all the way down onto the top of the rack.
MAKE SURE
the top of the rack is under the bottom of
the collar and that there is enough clearance to allow
the rack to freely rotate around the column. Tighten
the set screw
30
using the 3 mm hex wrench.
7. Install the table crank handle
15
onto the worm gear
shaft
31
on the side of the table bracket. (Fig. I)
8. Line up the flat side of the shaft with the set screw
32
in the crank handle and tighten the screw with the
3 mm hex wrench provided. Do not overtighten.
WARNING:
Many illustrations in this manual show
only portions of the drill press. This is intentional so
that points being made in the illustrations can be
highlighted. Never operate this drill press without
all guards securely in place and in good operating
condition.
ASSEMBLY AND ADJUSTMENTS
Estimated Assembly Time: 25-35 Minutes.
WARNING: For your safety, never connect plug to
power source receptable until all assembly and
adjustment steps are all complete, and you have
read and understood the safety instructions.
WARNING: The drill press is a heavy power tool
and should be lifted with the help of two people
OR MORE to safely assemble it.
Assembling Column To Base (Fig. D)
1. Remove the rack and rack ring from the column
assembly.
2. Position the base
4
on a flat and stable work surface
(must be able to support 100 lbs.).
3. Place the column assembly
26
on the base
4
. Align
the three mounting holes of the column assembly to
the holes of the base.
4.
Bag “g”
- Locate the three hex bolts
27
from the parts
bag.
5. Place a hex bolt
27
in each hole through the column
assembly and thread into the base. Tighten with a
13 mm wrench or adjustable wrench.
Fig. D
Installing The Table (Fig. E, F, G, H, I)
1.
Bag “g”
- Install the table lock handle
5
into the hole
at the rear of the table bracket
16
.
nOTE:
Install the handle from left to right, so it enters
the non-threaded side of the table bracket first.
2.
Bag “g”
- Insert the worm gear
28
into the table crank
handle hole
29
from inside of the table bracket
16
.
Make sure the worm gear
28
meshes with the inside
gear.
nOTE:
Do not remove the lubrication from this worm
gear.
3. Place the rack
17
into the inside of table bracket
16
as shown in Fig. F, making sure the worm gear
28
in
the table bracket
16
is engaged with the teeth of the
rack
17
and the arrow stamped on the rack is pointing
up.
28
5
16
29
4
26
27
Fig. E
17
5
Fig. G
Fig. F
17
28
16