11
ASSEMBLY
5.
Position the seat assembly over the seat mounting bracket, aligning the
holes provided. See Figure 7.
6.
Install the two shoulder bolts (a) and lock nuts (b) removed from the seat
mounting bracket (c) in Step 1. See Figure 7.
(a)
(a)
(b)
(b)
(c)
(a)
(b)
(c)
(d)
Figure 7
Note:
Make sure that the bolt’s shoulder is completely recessed into the seat
bracket when securing the lock nut.
7.
To adjust the position of the seat, loosen the adjustment knob (d) on the
bottom of the seat. Slide the seat forward or backward as desired. Securely
retighten the adjustment knob. Refer to Figure 7.
Installing the Deck Chute
WARNING
Never operate this tractor without either the mulch plug or deck chute
installed.
8.
Remove the wing knobs (a) installed on the mowing deck and retain for later
installation. See Figure 8.
(a)
(a)
(b)
(c)
(c)
(d)
(e) (f)
(g)
Figure 8
9.
Install the deck chute (b) into the deck discharge opening on the deck. The rear
of the chute should be under the tab (f) on the rear deck bracket (g). The studs
(c) on the deck surface will fit through the holes on the upper portion of the
deck chute. The small tab (d) on the deck lip area will fit through the square
cutout on the lower portion of the deck chute. See Figure 8.
Important:
Make certain that the upper-rear portion of deck chute (b) is
depressing the safety switch (e) located on the deck surface and under the
tab (f) on the rear deck bracket (g). The blade(s) will not start without the
deck chute (b) properly in place.
10. Secure the deck chute (b) by tightening the wing knobs (a) removed in step
1. See Figure 8.
Installing the Mulch Plug (If equipped)
WARNING
Never operate this tractor without either the mulch plug or deck chute
installed.
1.
Remove the wing knobs (a) installed on the mowing deck and retain for later
installation. See Figure 9.
(a)
(a)
(b)
(c)
(c)
(d)
(e)
(f)
(g)
Figure 9
2.
Install the mulch plug (b) into the deck discharge opening on the deck.
The rear of the mulch plug (b) should be under the tab (f) on the rear deck
bracket (g). The studs (c) on the deck surface will fit through the holes on the
upper portion of the mulch plug (b). The small tab (d) on the deck lip area
will fit through the square cutout on the lower portion of the mulch plug (b).
See Figure 9.
Important:
Make certain that the upper-rear portion of mulch plug (b) is
depressing the safety switch (e) located on the deck surface and under the
tab (f) on the rear deck bracket (g). The blade(s) will not start without the
mulch plug (b) properly in place.
3.
Secure the mulch plug (b) by tightening the wing knobs (a) removed in step 1.
Summary of Contents for CMXGRAM1130049
Page 46: ...NOTES 46 ...
Page 47: ...NOTES 47 ...
