background image

3-BUTTON REMOTE CONTROL

MODEL CMXZDCG453

To prevent possible SERIOUS INJURY or DEATH from 
a moving gate or garage door:
•   ALWAYS keep remote controls out of reach of 

children. NEVER permit children to operate or 
play with remote controls.

•   Activate gate or door ONLY when it can be seen 

clearly, is properly adjusted and there are no 
obstructions to door travel.

•   ALWAYS keep gate or garage door in sight until 

completely closed. NEVER permit anyone to 
cross path of moving gate or door.

For use with CRAFTSMAN

®

 garage door openers manufactured after January 1, 1993. The garage door opener 

activates when the programmed button on the remote control is pressed. The remote control can activate up to 
three garage door openers.

Make sure the garage door opener has a working light bulb because it is a programming indicator.

Locate the Learn 
button on the garage 
door opener.

NOTE:

 Your garage door 

opener may look different.

OR

OR

Learn 
LED

Learn 
LED

Learn 
LED

Green
or
Red/Orange

Purple

Yellow

Locate the Program button on the 
remote control.

Program Button

4

Press and release the Learn 
button on the garage door 
opener.

3

Now, press any remote-control
button 

except

 the button that

was selected in Step 2.

Install the visor clip.

7

Press the remote control button 
programmed in step 2 until the 
garage door opener lights flash 
or two clicks are heard. 

To test, press the programmed 
button on the remote control...

1

Within 30 seconds...

The Learn LED will light.

5

6

Press and hold the program button 
by using the visor clip until the LED 
on the front of the remote control turns 
on.

Learn
Button

Click

Click

The garage door 
opener will activate.

2

Press and release the remote control button you wish to use the 
number of times that corresponds with the garage door opener type:

# of Presses

Garage Door Opener Type

1
2
3
4

S 2.0

®

 (Yellow Learn Button)

S

®

 (Purple Learn Button)

S

®

 (Red/Orange Learn Button)

Billion Code (Green Learn Button)

LED

MODEL CMXZDCG453

PREPARE

PROGRAM THE REMOTE CONTROL

®

WARNING:

 This product can expose you to chemicals including lead, which are known to the State 

of California to cause cancer or birth defects or other reproductive harm. For more information go to 

www.P65Warnings.ca.gov

.

Summary of Contents for CMXZDCG453

Page 1: ... button on the remote control Program Button 4 Press and release the Learn button on the garage door opener 3 Now press any remote control button except the button that was selected in Step 2 Install the visor clip 7 Press the remote control button programmed in step 2 until the garage door opener lights flash or two clicks are heard To test press the programmed button on the remote control 1 Withi...

Page 2: ... this remote will not illuminate when the buttons are pressed To replace battery open the case as shown Insert battery positive side up Replace the battery with only 3V CR2032 coin cell batteries Dispose of old battery properly To prevent possible SERIOUS INJURY or DEATH NEVER allow small children near batteries If battery is swallowed immediately notify doctor To reduce risk of fire explosion or ...

Page 3: ...erente O O LED Learn LED Learn LED Learn Verde o Rojo Anaranjado Púrpura Amarillo Botón Program 4 Pulsar y soltar el botón Learn del abridor Colocar el gancho de visera 7 Pulsar el botón programado en el paso 2 del control remoto hasta que las luces del abridor parpadeen o se escuchen dos sonidos Para probar la función pulsar y soltar el botón programado en el control remoto Dentro de los siguient...

Page 4: ...con el lado positivo hacia arriba Use exclusivamente minibaterías 3V CR2032 Deseche la batería usada según corresponda Para evitar accidentes LESIVOS e incluso MORTALES NO permita que los niños entren en contacto con baterías Consulte a un médico inmediatamente si se tragara una batería Para reducir el riesgo de incendio explosión o quemadura química Utilice exclusivamente minibaterías 3V CR2032 N...

Reviews: