page 4
5. Fan Assembly.
Locate 3 pairs of screws in top of motor
housing and remove each of these screws.
Locate one RED DOT on top of motor housing
and one RED DOT on base at bottom of one
the rods on the downrod support.
Align the
red dots
and attach downrod support with six
screws that were just removed.
WARNING
:
Tighten each of the 6 screws in the
downrod support securely.
Connect plug from downrod support to plug
from motor housing. Make sure plugs
connect completely.
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common sense
and caution are necessary factors in the installation
and operation of this fan.
motor housing
motor housing
downrod support
red dot
plug
red dot
If you wish to extend the hanging length of
your fan, you must remove the hanging ball
from the downrod provided to use with an
extended downrod (sold separately). [
If you
wish to use the provided downrod, please
proceed to instructions on the following page.
]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove
stop pin. Slide hanging ball off the original
downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the
inside of the hanging ball. Tighten set screw
securely.
["Fan Assembly" continued on next page.]
set screw hole
set screw
hanging ball
stop pin
A
B
