page 8
9. Light Kit Assembly (Optional).
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted
holes in fitter plate with loosened screws
in motor plate, allowing molex
connections from motor housing to come
through hole in middle of fitter plate.
Twist fitter plate to lock. Re-insert screw
previously removed and securely tighten
all 3 screws with a Phillips screwdriver.
[
Refer to
diagram 1
.
]
If you wish to use the LED light kit
,
remove 1 screw from fitter plate and
partially loosen the other two screws.
Connect
WHITE
wire from motor housing
to
WHITE
wire from LED light kit. Connect
BLACK
wire from motor housing to
BLACK
wire from LED light kit. Be sure
molex connections snap together securely.
[
Note:
If you will NOT be using the LED
light kit, do NOT connect the molex.] Align
slotted holes in LED light kit with loosened
screws in fitter plate. Twist LED light kit to
lock. Re-insert screw that was previously
removed and tighten all 3 screws securely.
[
Refer to
diagram 2
.
]
Locate slots on glass shade and align with
nodules on inside of LED light kit.
Gently
push up on glass shade and turn
to the
RIGHT (clockwise)
until it slides completely
into place.
[
Refer to
diagram 2
.
]
If you do NOT wish to use the light
,
locate
slots on metal cover and align with
nodules on inside of
LED light kit
. Gently
push up on metal cover and turn to the
RIGHT (clockwise)
until it slides completely
into place.
[
Refer to
diagram 3
.
]
CAUTION
: D
o
not
connect the LED light
kit if you do NOT wish to use the light.
LED light kit
molex
connections
glass shade
slots
nodules
motor housing
fitter plate
molex connections
motor plate
motor housing
metal cover
diagram 2
diagram 1
diagram 3
screw
