5
TIPS: Different brands of embossing folders may require
different platform combinations (see page 8).
For greater pressure, insert the thin rubber embossing mat
or magnetic shim between Platform A and Platform D.
USING CRAFTWELL™ EMBOSSING FOLDERS
Position the cutting die, blade side up, smooth side
sitting on one Platform A.
Position the material over the cutting die then place
all on top Platforms B & D. Place the second Platform A
on top of the rest of the platforms. It should be directly
above the material.
Keeping the platform combination straight, guide
them into the Cut’n’Boss with a steady forward motion.
Release the platform when the rollers begin pulling the
platforms into the machine. A cracking sound is normal.
Remove the platforms once the motor stops running.
The top Platform A may have an impression, this is normal.
TIP:
Place the thin magnetic shim under the cutting die,
on top of Platform A if more pressure is needed.
Summary of Contents for Cut'n'Boss Limited Edition
Page 1: ......
Page 10: ...10 TROUBLESHOOTING CAUTION ...
Page 11: ...11 LIMITED WARRANTY ...
Page 12: ...CW MAN LE1 ...