6
Thick Magnetic Shim
Position the cutting die, blade side up, smooth side
sitting on the thick magnetic shim & one Platform A.
Position the material over the cutting die then place
all on top Platforms B & D. Place the second Platform A
on top of the rest of the platforms. It should be directly
above the material.
Keeping the platform combination straight, guide
them into the Cut’n’Boss with a steady forward motion.
Release the platform when the rollers begin pulling the
platforms into the machine. A cracking sound is normal.
Remove the platforms once the motor stops running.
The top Platform A may have an impression, this is normal.
TIP:
Place cutting dies on the platforms so that it will feed
the “long way,” or vertically, to evenly distribute pressure.
USING THIN METAL CUTTING DIES
Summary of Contents for Cut'n'Boss Limited Edition
Page 1: ......
Page 10: ...10 TROUBLESHOOTING CAUTION ...
Page 11: ...11 LIMITED WARRANTY ...
Page 12: ...CW MAN LE1 ...