GENERAL OPERATION:
1. Connected the unit to AC power as instructed earlier.
2. Slide the POWER ON/OFF Switch on the rear of unit to ON position to turn the unit to Standby Mode,
the Red Indicator on top of unit will illuminate.
3. Press and hold the Button on the top of unit or press the Button on the Remote Control to power on
the unit from Standby Mode. The Decorative LED Lights will illuminate and the color of the indicator on the
top of unit will turns to correspondence color as the playback source.
4. Press the SOURCE Button on the unit or press the SOURCE Button on the Remote Control repeatedly
to switch to the desired playback mode. The color of the indicator will turn to correspondent color with
your selection (see list below):
Color of Indicator:
Playback Source/Mode:
Blue BT (Bluetooth)
Teal FM Radio
Purple
LINE IN
Green AUX IN
5. Press the VOL +/- Buttons on the unit or Remote Control to adjust volume level as desire.
6. Press the /- Buttons on the Remote Control to adjust the treble (high audio frequency) level as desire.
7. Press the BASS +/- Buttons on the Remote Control to adjust the bass (low audio frequency) level as desire.
on speakers or front of unit.
Control to turn the unit to Standby Mode. The color of the indicator will turns to Red.
12. For saving energy, if you will not use the unit for an extended period of time. Slide the POWER ON/OFF Switch
BT MODE:
BT (Bluetooth) pairing:
First time use or re-pairing the unit to a new BT Device, pair as follows:
1. Power on the unit and enter to BT (Bluetooth) mode as the instructed earlier. The color of the indicator on
the top of unit will turns to Blue and blink.
2. Power on the external BT Device and enter to BT searching mode. Start pairing following the on screen
instructions from the external BT Device. When paired, the Blue BT Indicator will stop blinking.
3. If pairing is complete you may now play music with your external BT Device.
4. During playback:
l
Press the Button on the unit or the Button on Remote Control to pause, press again to resume
normal playback.
Press the TUNE -/ or TUNE +/ Buttons on the unit or Remote Control to Skip tracks.
Notes:
l
When the external BT Device searched the unit, our model number “CHT884” will appear on the display of external
BT Device.
l
If while pairing you are asked for a code please try "0000" or "1234".
Normal operation after pairing:
1. Power on the external BT Device and enter to BT playback mode.
2. Power on the unit and enter to BT (Bluetooth) mode as the instructed earlier. The color of the indicator on the
top of unit will turns to Blue and blink.
3. Wait a few seconds until the unit is automatically paired to the external BT Device. The blue indicator will stop blinking.
4. After pairing is complete you may now play music with your external BT Device.
l
OPERATION
9. Pr
10
11.
