Craig CHT923, Owner'S Manual

1.  Connect the Sound Bar to the power as previous procedures.

2.  Press the 

       Power button on the unit or remote control to power on the unit. 

3.  Press the SOURCE button on the unit or remote control repeatedly until FM Frequency 

shows on the LCD Display to turn to Radio ( FM ) mode.

4. In first time use:

  ~ Press and hold the       / TUNE - or      /TUNE + buttons approx. 1 second, then release 

to start auto searching the next or previous available station.

  ~ When the available FM station is searched, the unit will stop search then start playback.

  ~ Press the M/     button to enter to memory mode, the current program number will appear 

     on the display and blink.

  ~ Press the CH ( Channel ) + or - buttons on the remote control repeatedly to desired  

program number then press the M/     button to stored it.

  ~ Repeat the same procedures until all the desired available FM stations were stored. 

     ( Total 20 stations can be programmed.)
5. After programmed, press the CH + or - buttons to selected the desired programmed channel.

NOTE: If the AC power is cut off or failure, the stored program may be erased. Reset 

6. If reception no good, press the       or       buttons repeatedly to fine tune.

again as above procedures.

LISTEN TO FM RADIO

FM Antenna

 and extend the wire or relocate the wire to improve the radio reception.

The Antenna wire on the rear of the unit is for radio reception. If reception is weak, unwind

9

7. Press the MO/ST (Mono/Stereo) button repeatedly to set to Mono or Stereo mode as desire. 

4. During Playback:

~ Press the VOL ( Volume ) + or - buttons to adjust volume level as desired.

~ Press the EQ button repeatedly to select and set equalizer mode as desired.
~ Press      ( Mute ) button to turn off the sound. Press again to resume.

GENERAL OPERATIONS

1. Connect the AC/DC adapter to the unit and wall outlet as the previous procedure .

2. Press the      Power button on the unit or remote control to power on the unit from standby mode.

The LCD display will turn on.

6. If long period of time will not use the unit, unplug the AC/DC Adaptor from the wall outlet.

3. Press the SOURCE button repeatedly to 

  ~ Press the BASS +/- buttons to adjust the sound level of bass. 

  ~ Press the /- buttons to adjust the sound level of treble. 

5. When finished listening, press the      Power button on the remote control or unit to power off 

( Standby mode ) the unit. 

switch to desired mode.