7
Notes:
A.
Insert the card (Up to 32GB, not included) into the card slot on right side , The card metal chip
for your face
B.
To take out the card, press the card until a “click” is heard then pulls out the card.
C.
Before replacing the storage card, make sure the unit has been powered off.
D.
When inserting the storage card, make sure the direction you select is correct. Never insert
violently to avoid damaging the card or the unit. If the storage card doesn’t work, please check
if the direction is correct.
E.
When the card is used for the first time, or it has been used in another device, please format it
first through the Computer. You also need to download the desired music, photos and/or movie
onto the card before installing into the unit
Important: Formatting the Micro SD Card will delete all the data on the card. Download the
data to your computer before formatting the card.
Micro USB Port (USB OTG)
This device supports USB device for extending the memory size, or USB Thumb Drive, inserts the
supplied USB cable (micro USB plug to Full size USB female jack) into the micro USB port on the
side of unit. Insert USB device into Full size USB female jack, like in the PC.
Notes:
Before
replacing a USB drive, make sure the unit has been powered off.
When inserting the USB driver, make sure the direction you selected is correct. Never insert
violently to avoid damaging the USB driver or the unit. If it doesn’t work, please make sure if the
direction is correct.
Power on/off the Device
1.
Press and hold the
button on the right cabinet approximately 5 seconds to power on the
unit. Touch and slide the key bar shown on the screen to from bottom to top unlock
2.
In power on mode, press the
button to turn off the screen for saving battery power. Press
again to turn it on.
3.
To power off the device, press and hold the
button until the
“Power off” window pop up,
touch the “Power off” , the device will power off
Reset:
If the device becomes abnormal, halts, freezes. Press the RESET Button in the reset hole on the
rear of device (see figure as below) with a small screwdriver (not included) to reset the device.
RESET
