6.3
LUBRICATE THE BLADE
To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
•
Put the machine on a flat and smooth surface.
•
Use a soft cloth to clean the blades and a brush to remove
more dirt.
•
Use a light layer of oil to lubricate the blades along the
top edge of the blade.
NOTE
We recommend to use the non-pollutant type oil.
7
STORE THE MACHINE
NOTE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
8
TROUBLESHOOTING
Problem
Possible cause
Solution
The motor does
not start when you
pull the trigger.
The battery pack is
not installed tight-
ly.
Make sure that
you tighlty install
the battery pack in
the machine.
The battery pack is
out of power.
Charge the battery
pack.
The machine
smokes during op-
eration.
The machine has
damage.
1. Immediately
stop the ma-
chine.
2. Remove the
battery pack.
3. Speak to serv-
ice center.
The motor is on,
blades do not
move.
The machine has
damage.
Do not use the ma-
chine and speak to
service center.
The blades are
blocked.
Remove battery
pack then clear
blockage from the
blades.
Problem
Possible cause
Solution
There is too much
noise and/or vibra-
tion during opera-
tion.
The parts are loos-
en.
1. Stop the ma-
chine.
2. Remove the
battery.
3. Inspect for
damage.
4. Check and
tighten loose
parts.
The parts have
damage.
Do not use the ma-
chine and speak to
service center.
9
TECHNICAL DATA
Voltage
82V
No load speed
2800/3200/360
0/4000
(±10%) /min
Blade speed
2800/3200/360
0/4000
(±10%) /min
Blade length
620 mm
Cutting capacity
30 mm
Weight (without battery pack)
3.8 kg
Measuered sound pressure level
89.3 dB(A),
K
PA
=3 dB(A)
Guaranteed sound power level
97 dB(A)
Vibration
3.7 m/s
2
Uncertainty
1.5 m/s
2
10
EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name:
GLOBGRO AB
Globe Group Europe
Address:
Propellergatan 1, 211 15 Malmö, Sweden
Name and address of the person authorised to compile the
technical file:
Name:
Peter Söderström
Address:
Propellergatan 1, 211 15 Malmö, Sweden
Herewith we declare that the product
Category:
Hedge Trimmer
6
English
EN
Summary of Contents for 2200486
Page 2: ......
